Cause
- Lack of pressure at the main hydraulic block.
Correction
- Increase pressure by tightening the relief valve to reach 3000 psi on the gauge when the saw is activated.
Cause
- Lack of hydraulic oil.
Correction
- Check that the hydraulic oil level in the processor is sufficient.
Cause
- Relief valve adjustment.
Correction
- If the saw and conveyor pressures are correct, the hydraulic relief block may need adjustment. By unscrewing the adjustment knob, the pressure should increase.
Cause
- Internal leak in the splitter cylinder.
Correction
- The splitter cylinder must be replaced.
Cause
- Internal damage in the hydraulic relief block.
Correction
- The hydraulic relief block must be replaced.
